Repeat the jute tieing, stapling, and wrapping process on the others angle of the tree.Finish this angled side by wrapping the jute a couple of times around the rung and tieing the end off. Continue this process until you get to the top rung.Bringing the same piece of jute up to the next rung, wrap it around the twig 2 times, (the jute should be positioned slightly angled in), staple the jute in place.Wrap the jute once and staple it in place again. Tie your jute to one end of the bottom twig (the longest one), then staple it in place.Make sure your tree branches are positioned how you want them to be as a finished project.Using a saw, cut along the mark to shorten your twigs.Following the 2nd angle aid, mark a line on your twigs to be cut.Take another similar angle aid and lie it on the other side of your “tree”.Move the twigs flush up against your chosen angle aid.Using one of your angle aids, lie the aid on the side of your “tree” to get the desired angle of your tree.(See that stump at the bottom? We were winging it and ended up NOT using it so let’s just pretend it’s not there.) Lie them out on the ground to get them to the desired graduated pattern.Gather twigs that are of similar diameter and are fairly straight.Measure to figure out what the optimal width your tree should be. Find the stud on the wall you plan to hang your twig tree.two angle aids scrap wood, string, or tape measurer long enough to lay along the side. So here is how we did it! How to DIY a Twig Christmas Tree Materials: This beauty was so easy to make, I’m kicking myself for not making one while we lived in an RV!
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |